Minimum spouting velocity of fine particles in fountain confined conical spouted beds
View/ Open
Date
2020-07-25Author
Estiati Larrea, Idoia
Altzibar Manterola, Haritz
Aguado Zárraga, Roberto
Metadata
Show full item record
Powder Technology 374 : 597-608 (2020)
Abstract
[ES] Se ha desarrollado un novedoso dispositivo interno denominado confinador de la fuente, que estabiliza el sistema y permite operar con partículas finas, incluso sin ningún tipo de tubo central. Dada la estabilidad que este dispositivo confiere al sistema, se requieren velocidades mínimas de spouting menores que en los sistemas convencionales, por lo que las correlaciones de la literatura sobreestiman este parámetro hidrodinámico. Por ello, se han realizado ensayos con este novedoso dispositivo para estudiar la hidrodinámica y la influencia que tienen los factores geométricos y operativos sobre la velocidad mínima de spouting en spouted bed cónicos de fuente confinada, con y sin tubos centrales. Los lechos están formados por arena fina y partículas de aserrín. A partir de un diseño experimental se pudo comprobar que, aunque ciertos factores influyen en determinadas configuraciones, los de mayor influencia en todas las configuraciones son las propiedades del sólido, la altura del lecho estático y el diámetro de entrada del gas. Por lo tanto, se han propuesto nuevas correlaciones para predecir la velocidad mínima de spouting en cada configuración. [EN] A novel internal device called fountain confiner has been developed, which stabilizes the system and allows operating with fine particles, even without any type of draft tube. Given the stability this device confers upon the
system, lower minimum spouting velocities than in conventional systems are required, and therefore the correlations in the literature overestimate this hydrodynamic parameter. Accordingly, runs have been carried out
using this novel device in order to study the hydrodynamics and the influence geometric and operating factors
have on the minimum spouting velocity in fountain confined conical spouted beds, with and without draft
tubes. The beds are made up of fine sand and sawdust particles. Based on an experimental design, it was
ascertained that, although certain factors are influential in given configurations, those of greater influence in
all the configurations are the solid properties, static bed height and gas inlet diameter. Therefore, new correla-
tions have been proposed for predicting the minimum spouting velocity in each configuration.