Search
Now showing items 11-16 of 16
Small Form-Factor Driver for Power LEDs Powered with One Element Battery
(Springer, 2011)
The present paper is focused on designing small form-factor drivers for high-power LEDs, which are fed with one battery element. Standard power supply architectures are not suitable due to the design requirements and ...
Analysis of GaN Series Capacitor Buck converter in point-of-load aerospace applications
(SAAEI, 2021-07-07)
Recently, atmospheric research has been increasingly conducted by both industry and universities by means of small spacecrafts, such as CubeSats, which offer an affordable cost due to the availability of the satellite inner ...
Analysis of impedance and current distributions in parallel IGBT design
(IEEE, 2017-08-07)
Power electronic applications need high voltage and current ranges which are impossible to obtain with discrete devices. Parallelization technique is a solution to increase power converter current capacity. Current ...
Analysis and modelling of IGBTs parallelization fundamentals
(IEEE, 2016-12-22)
In some power electronic applications, with high current and voltage ranges, discrete devices are not enough unless parallelization techniques are employed. IGBTs are one of the most common and widespread power electronic ...
Functional Verification for SEU Emulation in FPGA Designs
(2014-09-17)
In this paper techniques to detect failures in a FPGA are presented and their application to SEU
(Single Event Upset) emulation applications is discussed. SEU emulation in FPGAs consists on
programming the device with a ...
Fault Injection System for SEU Emulation in Zynq SoCs
(IEEE, 2014-11-26)
This paper presents a fault injection method for SEU (Single Event Upset) emulation in FPGAs based on loading at the programmable logic a configuration file with an erroneous bit. A "Xilinx Zynq®-7000 All Programmable SoC" ...